
LABSBIO ENHANCED HUMANS
DermaGlowGlow
Three peptides in a single vial for skin: the copper that orchestrates collagen, plus two repair peptides that speed up regeneration. Applied by syringe, subcutaneously.

For research use only.
GHK-Cu
Stimulates fibroblasts and collagen and elastin synthesis. It is the engine of the blend.
TB-500
Remodels the matrix and improves cell migration: skin repairs faster.
BPC-157
Anti-inflammatory and healing; sustains the result between sessions.
Firmer, more luminous skin that repairs itself faster.
- Firmness and glow within 6–12 weeks of consistent use.
- Less marked fine lines and more even texture.
- Faster regeneration after procedures.
- More even tone; hyperpigmentation fades gradually.
★ IN ONE LINE
If GHK-Cu alone gives you fine dose control, Glow gives you the protocol ready-made: one injection instead of three, with balanced ratios. It carries copper, so it is cycled.
WHAT IT'S FOR
GHK-Cu has solid human evidence topically for wrinkles and firmness; the injectable route has no human trials and we say so plainly. Do not combine it at the same time with high-concentration vitamin C or with glutathione: copper oxidizes or gets chelated and you lose both. Separate them by at least 30 minutes, and always keep glutathione in a separate syringe.
YOUR PROTOCOL
From prep to application
Wash your hands
Clean the stoppers with 70% alcohol
Draw 3 ml of bacteriostatic water (BAC)
Inject the water down the vial wall (not onto the powder)
Swirl gently until dissolved (do not shake)
Label and refrigerate (2–8 °C)
| KEY PARAMETERS | |
| Vial | 70 mg |
| Water to add | 3 ml |
| Concentration | 23.33 mg/ml |
| Dose (U-100) | 6 → 9 → 12 u |
| Route | Subcutáneo |
★ GOLDEN RULE
Titrate by units, not by days: 6 to 9 to 12, and only when your skin holds up without redness. At 12 units you are already at 2 mg of copper, the reasonable daily ceiling. Apply at night, rotate the site and respect the off-weeks: copper accumulates.
on the sides
upper outer quadrant
outer side
back of arm
- Clean the site with 70% alcohol and let dry.
- Draw the dose in a U-100 syringe (29G). Remove air.
- Pinch the skin and insert the needle at 45–90°.
- Inject slowly, withdraw and press (do not rub).
- Rotate the site. Discard the needle in a sharps bin.
EVERYTHING THAT MATTERS
Safety, monitoring & results
Stinging on application
Normal with copper. At night and rotating the area it is easier.
Transient blue tint
It is the copper. It fades on its own within hours.
Local redness
Usually lasts 15–30 minutes. Beyond 48 h, lower the dose.
Copper buildup
That is why the cycle has off-weeks. Do not skip them.
WHEN TO SEE A DOCTOR?
- Wilson disease or copper hypersensitivity: do not use
- Pregnancy or breastfeeding: do not use
- Site redness that does not fade within 48 hours
- Allergic reaction: hives, swelling, difficulty breathing
This protocol is a general guide. Every body is unique. Work with your doctor to personalize your plan.